In some cases, it may be necessary to remove the lids and the side covers to gain access to certain areas of the lane machine.

Conditioner Compartment Lid Removal

To remove the set the machine down into the operating position.

Slide the conditioning compartment lid back a few inches to where you can reach your hand under the lid. Locate the lid pin ring and pull the spring-loaded pin from the pin guide. Do the same for the opposite side. 

Tilt the lid assembly up and pull the other spring-loaded pins out of the guide and lift the lid assembly up and out of the lane machine.   

Cleaning Compartment Lid Removal

To remove the cleaner compartment lid, you must first remove the conditioner compartment lid. 

Once the conditioner compartment lid is removed, slid the lid all the way to the read of the lane machine and lift the lid up and out of the machine. 

Side Guard Removal

With the machine in the upright transport position, locate the two screws on each side of the machine that mount the bottom of the side cover and remove. 

Set the machine down into the operating position. There are two screws located on the inside of the lane machine that attach each of the side guard assemblies to the lane machine. One is located in the oil compartment and the other is located in the cleaning compartment. Once you remove these screws the side guards can be removed.

Rear Guard Removal

With the lane machine in the upright position, locate the 2 screws holding the rear guard to the lane machine as shown. 

Remove all four casters. After removing the last one, the panel will then come off. There are two plugs that will be attached to the panel. Unplug these and the panel will be free from the machine.