Sensor Guard Installation

• Sensor guard installation should be done after the initial calibration and leveling of the      sensor.
• Remove the Guard Assembly from the package and using the button head allen bolts,         tighten the support braces to the top plate.
• Take the aluminum mounting support brackets and finger tighten the hardware to               them. 
• Position the guard over the sensor allowing a minimum of ½” gap between the top              plate and the sensor.
• With the guard level from front to back and from and side to side, use a black marker          and mark where the lag bolts will be screwed in. 
• Using the supplied lag bolts fasten all of the mounting angles into place.
• Tighten the guard into place. 
• After the sensor guard has been installed a hole will need to be made in the capping.
• Using the template below mark the capping based on the actual location of the sensor.
• This hole, when done, should yield ample border to safely remove the capping without      damaging the sensor.